Fountain Pen Won’t Start Writing? How to Fix a Slow Starting Nib

Fountain Pen Won’t Start Writing? How to Fix a Slow Starting Nib

You uncap your fountain pen, put it to paper and nothing happens. A few seconds later the ink finally appears. This is called a hard start or slow start, and it’s one of the most common frustrations fountain pen users face. The good news is that it’s often easy to fix. Even better, understanding why it happens will make you a more confident pen owner.

What is a slow starting nib?

A slow start happens when ink doesn’t reach the tip of the nib quickly enough after the pen has been sitting. You may see a skipped first stroke, a faint line that darkens as you write, or a few seconds of scratching before the ink flows.

Why it happens

Most slow starts come from one of a handful of causes:

  • Dried ink on the nib. Even a thin film of dried ink can block the slit at the tip.
  • A dried-out feed. The feed is the plastic or ebonite part under the nib that carries ink forward. If it dries, ink has a harder time moving.
  • A loose cap seal. If air gets into the cap, ink evaporates faster at the nib.
  • Thick or dry ink. Some inks flow more slowly than others, especially if they have been open a long time.
  • Residue from manufacturing. A brand-new pen may have a thin oily film on the nib or feed that repels ink.
  • Air bubbles or low ink. A bubble in the feed or a nearly empty reservoir can interrupt the flow.
  • Dirt or buildup. Old ink, paper fibers or shimmer particles can clog a feed over time.
  • Nib misalignment. If the nib’s two halves, called tines, are not lined up properly, ink can’t travel smoothly to the tip. More on this below.

Quick fixes to try first

Start with the simplest remedies:

  1. Wipe and wait. Gently wipe the nib with a damp paper towel to remove dried ink, then try again.
  2. Touch the nib to wet paper. Press the tip lightly against a damp paper towel so water can pull ink forward.
  3. Dip the nib in water. Dip just the tip, then blot the excess on a paper towel. This often dissolves dried ink at the tip.
  4. Prime the feed. If your pen uses a converter or cartridge, gently squeeze or turn it to push a little ink toward the nib. Go slowly so you don’t flood the pen.
  5. Write with the nib down. Hold the pen nib-down for a few seconds before writing so gravity helps pull ink to the tip.

Deeper fixes

If quick fixes don’t solve it, try a full cleaning.

  • Flush with water. Rinse the pen with clean, room-temperature water until it runs clear. Flush several times, since ink often hides in the feed.
  • Use a mild soap solution. A drop of unscented dish soap in a cup of water can break up residue. Rinse thoroughly afterward.
  • Wash a new pen. If a brand-new pen starts slowly, a gentle wash with mild soap and water often removes the manufacturing film.
  • Check the ink. If the problem began after a new bottle, try a different ink to see whether it’s the cause. A wetter ink may flow more readily.
  • Reseat the converter or cartridge. Make sure it’s fully pushed in or screwed down.

If the pen is clean, filled properly and still starts slowly, it’s time to look at the nib itself.

Is your nib misaligned?

A nib is a small, precisely shaped piece of metal. The two tines must meet cleanly at the tip, with a hairline slit between them, so that ink flows by capillary action, the same force that pulls water up a paper towel. If the tines are even slightly out of position, that flow suffers. Misalignment can happen from a drop, from pressing too hard while writing, or from poor factory quality control, and some pens ship that way.

What to look for

You’ll need good light and ideally a jeweler’s loupe, a small magnifier that typically provides 10x magnification and costs just a few dollars. Look at the nib head-on, with the tip pointed at your eye, and check for these signs:

  • Uneven tines. One tine sits higher than the other, creating a tiny step at the tip. This is the most common problem.
  • Overlapping or crossed tines. One tine is pushed past the other instead of meeting it side by side.
  • Tines too tight. The slit is closed so completely that ink can’t pass through. No light shows through the slit when you hold the nib up to a lamp.
  • Tines too far apart. The slit is visibly wide at the tip. Ink flow may be too wet or the line may look doubled.
  • Nib off center. The slit does not line up with the center of the feed beneath it.
  • A gap between nib and feed. The nib should sit snugly against the feed. Even a small gap can interrupt the ink’s path.

Symptoms while writing

  • Hard starts or skipping, especially at the beginning of a stroke
  • Scratchy or catching feeling on the page, often when writing in one direction
  • Railroading, meaning two thin parallel lines instead of one smooth line
  • Inconsistent line width or ink flow

Keep in mind that these symptoms can also come from dirty feeds or poor ink, so always clean the pen first and test again before assuming the nib is the culprit.

How to test

Write a series of figure eights, circles and straight lines in every direction on smooth paper. Note any direction where the nib catches or skips. Then examine the tip under magnification. A well-aligned nib shows two level tines meeting evenly at the tip.

How to correct minor misalignment

Many people choose to leave nib work to a specialist, and that’s a wise choice for a valuable pen. If you want to try fixing minor problems yourself, do so only on an inexpensive pen first, work in tiny increments and stop if you feel resistance. Remember that adjusting a nib yourself may void the warranty.

Basic tools: A loupe, good lighting, a soft cloth, and for tight tines, a very thin brass shim, which is a sheet of thin brass sold by pen supply shops for exactly this job.

To level uneven tines: If one tine sits higher than the other, remove the nib and feed from the pen if it can be done easily. With the nib held between your thumb and forefinger, apply very light pressure to nudge the higher tine down or the lower one up. Check with the loupe after every tiny adjustment. Small movements make a big difference.

To open tines that are too tight: Slide a thin brass shim into the slit just far enough to open it slightly, then draw it out. Test the pen. Repeat only if needed, and never force the shim.

To realign the nib on the feed: If the nib has drifted off center, use a folded piece of paper towel and gently move the feed with your thumbnail so that the tines are perfectly centered to the feed.  For significant misalignment, like after a drop or accident, remember that the nib and feed sit within a circular housing.  Therefore, gently place the feed on your thumb and press your index finger on the backside of the nib.  You can turn one, the other or both gently so that they are aligned in a circular motion.

Avoid these mistakes:

  • Don’t use pliers, knives or other metal tools to bend a nib.
  • Don’t flex the nib hard to try to straighten it. That can spring the tines apart permanently.
  • Don’t press hard. If a tine doesn’t move with gentle pressure, stop.
  • Don’t use harsh chemicals on the nib or feed.
  • Be especially careful with gold nibs, which are softer and bend more easily than steel.
  • If you see cracked or missing tipping material, the small bead of hard metal at the very tip, stop and seek professional help.

When to get help

If your pen still starts slowly after a thorough cleaning, a change of ink and a careful alignment check, contact the pen’s manufacturer or a trusted nib specialist. Many manufacturers will adjust or replace a poorly aligned nib at no cost if the pen is new. Specialists, often called nibmeisters, can also perform precise adjustments quickly and at modest prices. For a pen you love, professional help is a small investment that protects your pen.

Prevent slow starts

A few habits help:

  • Cap your pen firmly when you aren’t writing, and make sure the cap snaps or screws on completely.
  • Use your pens regularly. Pens that sit unused for weeks are more likely to start slowly.
  • Store pens horizontally or nib down so ink stays near the tip.
  • Clean your pen every month or two. Clean more often if you use shimmer or very dark inks, which leave more buildup.
  • Match ink and pen. Some pens run dry with certain inks, so adjust if your pen frequently struggles.
  • Keep ink bottles sealed to avoid thick, evaporated ink.
  • Write with a light touch. Pressing too hard is a common way to spring a nib out of alignment.

The bottom line

A slow starting nib is usually a sign of dried ink, a dirty feed, a pen that’s been sitting too long or a nib that’s slightly out of alignment. Start with the easy fixes, move to a thorough cleaning and then take a careful look at the tip. With a little patience and a gentle hand, most pens are writing smoothly again in minutes.

 

Back to blog

Leave a comment